Clearing Vendors: Difference between revisions

From CasperTech Wiki
Jump to navigation Jump to search
Line 18: Line 18:
=== "Not Authorized" message when trying to scan ===
=== "Not Authorized" message when trying to scan ===
----
----
This may happen when you have manager (or higher) access to more than one copy of the CasperLet system. When the system is told to begin a scan, it will attempt to scan for ALL accessible copies of the systems. When one or more of them fails, you get an error message like the following:  
This may happen when you have manager (or higher) access on CasperLet for someone else's system. When the system is told to begin a scan, it will attempt to scan for ALL CasperLet systems you can access. When one or more of them fails, you get an error message like the following:  


   '''''Couldn't schedule a scan for units owned by ((number)) avatar(s) due to insufficient permissions'''''
   '''''Couldn't schedule a scan for units owned by ((number)) avatar(s) due to insufficient permissions'''''


The system(s) that you DO have scan access for, will allow the scan to run, even though the error message comes out for the ones you can't run the scan on.
This message will '''never''' affect a scan for your own copy of CasperLet.


=== Important Note ===
=== Important Note ===

Revision as of 19:50, 20 October 2015

Rental Units on Website That Shouldn't Be?

This is normal if a rental unit has been Edit > Deleted out of the world without using the popup "delete" option, or if the unit(s) have been sent back to your lost and found.

There are two ways to fix this:

  1. Use the website "Scan" function (Only click it ONCE, and be prepared to wait a while, likely a few hours, depending on the system load.)
  2. Go into "Units" tab, tick the boxes for each rental unit that shouldn't be there, then select "Delete".

The scan function does NOT add units to the website list. Rental units will pop back up when they are contactable again, or when you or a customer clicks them and uses one of the functions.

Checking status of "Scan" function


  1. Log in to CasperLet
  2. Click "Job Lots" - you'll see a list of all the scans you've tried to run.

You should have only one listed - if you have several, it will exponentially increase the amount of time it takes for the site to check the rental units....again and again and again and again.


"Not Authorized" message when trying to scan


This may happen when you have manager (or higher) access on CasperLet for someone else's system. When the system is told to begin a scan, it will attempt to scan for ALL CasperLet systems you can access. When one or more of them fails, you get an error message like the following:

  Couldn't schedule a scan for units owned by ((number)) avatar(s) due to insufficient permissions

This message will never affect a scan for your own copy of CasperLet.

Important Note


Please note: NONE of these methods will force a rental unit to suddenly appear on the website. These methods will only REMOVE rental units from the site list that are not currently contactable.

This may remove rental units from the list that are still inworld - this is normal, if they're not currently able to be seen (due to sim/region-to-website communication issues) - they will return once they are actually used inworld.